Wildlife by State

Rose-bellied Lizard

Sceloporus variabilis

The Rose-bellied Lizard (Sceloporus variabilis) is a lizard in the family Phrynosomatidae. USGS maps its range in one of the lower 48 states, Texas, where it covers 15% of the state. Adults reach up to 3.0 in (77 mm) from snout to vent and can weigh up to 0.6 oz (16 g).

Rose-bellied Lizard
Photo: Javier Hernandez, CC BY 4.0, via iNaturalist. Resized.

It is active by day. It lives in trees, among rocks and on the ground. It eats mainly other animals.

The USGS habitat model maps it in 6 land-cover types, among them Tamaulipan Mesquite Upland Scrub, Tamaulipan Mixed Deciduous Thornscrub and Edwards Plateau Limestone Savanna and Woodland.

Open-licence records from the lower 48 (488 of them) peak in April and are fewest in December. A typical clutch or litter is about 3.9. The longest recorded lifespan is 1.5 years.

By size, range and water use in the USGS models, the species most easily taken for it are the Common Side-blotched Lizard, the Many-lined Skink, the Common Lesser Earless Lizard and the Green Anole.

Where the Rose-bellied Lizard lives

Mapped range of the Rose-bellied Lizard in the lower 48 states. Source: USGS Gap Analysis Project range maps, which do not cover Alaska or Hawaii.
StateShare of stateCountiesOpen recordsPeak month
Texas 15% 42 of 254 660 April

Share of state is the part of each state inside the range map. Counties counts those with at least a tenth of their area in range. A state link opens that state's full list.

When it is recorded

January: 28JFebruary: 37FMarch: 52MApril: 62AMay: 47MJune: 41JJuly: 40JAugust: 55ASeptember: 49SOctober: 44ONovember: 27NDecember: 6D
Open-licence records by month across the lower 48 (488 records). Counts follow observers as well as animals.

Species it can be taken for

Chosen by rule: the same group, an adult size within 30%, at least one shared state and the same water use in the USGS habitat models. It is a list of candidates, not an identification.

Sources

How each figure is derived is set out on the methods page.