Wildlife by State

Striped Racer

Masticophis lateralis

The Striped Racer (Masticophis lateralis) is a snake in the family Colubridae. Older lists, including the USGS range data, name it Coluber lateralis. USGS maps its range in one of the lower 48 states, California, where it covers 48% of the state. Adults reach up to 5.0 ft (1,520 mm) in total length and can weigh up to 12.0 oz (339 g).

Striped Racer
Photo: Chris Brown, CC BY 4.0, via iNaturalist. Resized.

It is active by day. It lives on the ground.

The USGS habitat model maps it in 33 land-cover types, among them California Mesic Serpentine Grassland, California Northern Coastal Grassland and California Lower Montane Blue Oak-Foothill Pine Woodland and Savanna. The model places it no higher than 2,250 m (7,400 ft).

Open-licence records from the lower 48 (1,532 of them) peak in May and are fewest in December. A typical clutch or litter is about 8.

By size, range and water use in the USGS models, the species most easily taken for it are the Baja California Ratsnake, the Long-nosed Snake, the Western Rattlesnake and the Red Diamond Rattlesnake.

Where the Striped Racer lives

Mapped range of the Striped Racer in the lower 48 states. Source: USGS Gap Analysis Project range maps, which do not cover Alaska or Hawaii.
StateShare of stateCountiesOpen recordsPeak month
California 48% 50 of 58 1,636 May

Share of state is the part of each state inside the range map. Counties counts those with at least a tenth of their area in range. A state link opens that state's full list.

When it is recorded

January: 10JFebruary: 26FMarch: 89MApril: 333AMay: 391MJune: 251JJuly: 135JAugust: 98ASeptember: 109SOctober: 62ONovember: 22NDecember: 6D
Open-licence records by month across the lower 48 (1,532 records). Counts follow observers as well as animals.

Species it can be taken for

Chosen by rule: the same group, an adult size within 30%, at least one shared state and the same water use in the USGS habitat models. It is a list of candidates, not an identification.

Sources

How each figure is derived is set out on the methods page.