Wildlife by State

Wulfila albens

Wulfila albens

Wulfila albens is a spider in the family Anyphaenidae with no English name on file. Open-licence records place it in 4 states under the records rule (ten or more records in three or more years), most of them in Virginia (74 of 165 records nationwide).

Wulfila albens
Photo: Yann Kemper, CC0, via iNaturalist. Resized.

The most records come from Virginia (74), Georgia (33) and Alabama (14). In Virginia it has been recorded in 8 different years since 2000, 74 open-licence records in all.

Open-licence records from the lower 48 that carry a month (165 of them) peak in October and are fewest in December.

Where the Wulfila albens is recorded

Alaska: 0Alabama: 14Arkansas: 0Arizona: 0California: 0Colorado: 0Connecticut: 0Delaware: 0Florida: 0Georgia: 33Hawaii: 0Iowa: 0Idaho: 0Illinois: 0Indiana: 0Kansas: 0Kentucky: 0Louisiana: 0Massachusetts: 0Maryland: 13Maine: 0Michigan: 0Minnesota: 0Missouri: 0Mississippi: 0Montana: 0North Carolina: 0North Dakota: 0Nebraska: 0New Hampshire: 0New Jersey: 0New Mexico: 0Nevada: 0New York: 0Ohio: 0Oklahoma: 0Oregon: 0Pennsylvania: 0Rhode Island: 0South Carolina: 0South Dakota: 0Tennessee: 0Texas: 0Utah: 0Virginia: 74Vermont: 0Washington: 0Wisconsin: 0West Virginia: 0Wyoming: 0
Open-licence records of the Wulfila albens by state, for states meeting the records rule. Source: GBIF, CC0 and CC BY records only.
StateOpen recordsYearsPeak month
Virginia748October
Georgia336September
Alabama145
Maryland134

A state is listed with ten or more open-licence records of the species in three or more years since 2000. No range map exists for this species in the sources this site uses; records follow observers as well as animals, so a missing state is not shown to be an absence.

When it is recorded

January: 1JFebruary: 6FMarch: 4MApril: 22AMay: 21MJune: 22JJuly: 9JAugust: 3ASeptember: 19SOctober: 34ONovember: 24NDecember: 0D
Open-licence records by month (165 records). Counts follow observers as well as animals.

Sources

How each figure is derived is set out on the methods page.