Wildlife by State

Rabbits and hares in Massachusetts

4 species of rabbits and hares have a mapped range in Massachusetts. The most widespread is the Eastern Cottontail, mapped across all of the state.

The most restricted is the Black-tailed Jackrabbit, mapped in under 1% of the state.

The longest is the Black-tailed Jackrabbit, at 20 in (505 mm); the shortest is the New England Cottontail, at 15 in (371 mm).

USGS marks 2 of them as introduced in the state: the Eastern Cottontail and the Black-tailed Jackrabbit.

The most species are mapped in Plymouth County (3); the fewest in Bristol County (2).

Open-licence records in the state (1,302 of them) peak in May and are fewest in February.

The most often recorded is the Eastern Cottontail, with 1,234 open-licence records in the state.

Mapped ranges of the 4 species in Massachusetts. Darker areas are shared by more than one. Source: USGS Gap Analysis Project.
  • Eastern Cottontail
  • Snowshoe Hare
  • New England Cottontail
  • Black-tailed Jackrabbit
January: 39JFebruary: 22FMarch: 63MApril: 169AMay: 266MJune: 250JJuly: 195JAugust: 117ASeptember: 68SOctober: 51ONovember: 26NDecember: 36D
Open-licence records of rabbits and hares in Massachusetts by month (1,302 records). Counts follow observers as well as animals.
Sort:
SpeciesSizeShare of MassachusettsActiveRecords
Eastern Cottontail introduced
Sylvilagus floridanus Leporidae
16 in (400 mm) bodyallnight1,234
Snowshoe Hare
Lepus americanus Leporidae
17 in (442 mm) body96%night24
New England Cottontail
Sylvilagus transitionalis Leporidae
15 in (371 mm) body14%night55
Black-tailed Jackrabbit introduced
Lepus californicus Leporidae
20 in (505 mm) bodyunder 1%night1

Share of Massachusetts is the part of the state inside the species' USGS range map. Size is the largest on record where the source gives a maximum, otherwise a typical adult. Records are open-licence observations and specimens in the state; a blank means none were counted, not that the species is absent.

Sources

How each figure is derived is set out on the methods page.