Wildlife by State

Weasels, otters and badgers in North Carolina

4 species of weasels, otters and badgers have a mapped range in North Carolina. 3 are mapped across the whole state, among them the American Mink, the Long-tailed Weasel and the North American River Otter.

The most restricted is the Least Weasel, mapped in 22% of the state.

The longest is the North American River Otter, at 2.4 ft (722 mm); the shortest is the Long-tailed Weasel, at 9.8 in (248 mm).

The most species are mapped in Yancey County (4); the fewest in Alamance County (3).

Open-licence records in the state (527 of them) peak in February and are fewest in October.

The most often recorded is the North American River Otter, with 474 open-licence records in the state.

By the trait records, 3 are active at night and 1 is active by day and by night.

Mapped ranges of the 4 species in North Carolina. Darker areas are shared by more than one. Source: USGS Gap Analysis Project.
  • American Mink
  • Long-tailed Weasel
  • North American River Otter
  • Least Weasel
January: 111JFebruary: 206FMarch: 25MApril: 13AMay: 22MJune: 14JJuly: 23JAugust: 14ASeptember: 10SOctober: 6ONovember: 25NDecember: 58D
Open-licence records of weasels, otters and badgers in North Carolina by month (527 records). Counts follow observers as well as animals.
Sort:
SpeciesSizeShare of North CarolinaActiveRecords
American Mink
Mustela vison Mustelidae
17 in (430 mm) bodyallnight72
Long-tailed Weasel
Mustela frenata Mustelidae
9.8 in (248 mm) bodyallday and night51
North American River Otter
Lontra canadensis Mustelidae
2.4 ft (722 mm) bodyallnight474
Least Weasel
Mustela nivalis Mustelidae
10 in (260 mm) body22%night11

Share of North Carolina is the part of the state inside the species' USGS range map. Size is the largest on record where the source gives a maximum, otherwise a typical adult. Records are open-licence observations and specimens in the state; a blank means none were counted, not that the species is absent.

Sources

How each figure is derived is set out on the methods page.