Wildlife by State

Skinks in Alabama

6 species of skinks have a mapped range in Alabama. The most widespread is the Little Brown Skink, mapped across all of the state.

The most restricted is the Mole Skink, mapped in 30% of the state.

The heaviest is the Broad-headed Skink, at 2.4 oz (68 g); the lightest is the Little Brown Skink, at 0.1 oz (3.9 g).

The most species are mapped in Talladega County (6); the fewest in Jackson County (3).

Open-licence records in the state (929 of them) peak in April and are fewest in December.

The most often recorded is the Little Brown Skink, with 315 open-licence records in the state.

Mapped ranges of the 6 species in Alabama. Darker areas are shared by more than one. Source: USGS Gap Analysis Project.
  • Little Brown Skink
  • Common Five-lined Skink
  • Broad-headed Skink
  • Southeastern Five-lined Skink
  • Coal Skink
  • Mole Skink
January: 17JFebruary: 30FMarch: 144MApril: 284AMay: 153MJune: 83JJuly: 54JAugust: 44ASeptember: 51SOctober: 44ONovember: 20NDecember: 5D
Open-licence records of skinks in Alabama by month (929 records). Counts follow observers as well as animals.
Sort:
SpeciesSizeShare of AlabamaActiveRecords
Little Brown Skink
Scincella lateralis Scincidae
2.3 in (59 mm) snout to ventallday315
Common Five-lined Skink
Plestiodon fasciatus Scincidae
3.4 in (86 mm) snout to ventallday275
Broad-headed Skink
Plestiodon laticeps Scincidae
5.6 in (143 mm) snout to vent94%day213
Southeastern Five-lined Skink
Plestiodon inexpectatus Scincidae
3.5 in (89 mm) snout to vent91%day147
Coal Skink
Plestiodon anthracinus Scincidae
2.8 in (70 mm) snout to vent48%day27
Mole Skink
Plestiodon egregius Scincidae
2.5 in (64 mm) snout to vent30%day67

Share of Alabama is the part of the state inside the species' USGS range map. Size is the largest on record where the source gives a maximum, otherwise a typical adult. Records are open-licence observations and specimens in the state; a blank means none were counted, not that the species is absent.

Sources

How each figure is derived is set out on the methods page.